U424AA - 2K Wire-Free Camera : Installation

This article provides instructions to install your Lorex 2K Wire-Free Camera (U424AA).

The camera battery comes partially charged (due to safety regulations). Please, fully charge the battery before use and setup to take full advantage of the Wire-Free camera. For full instructions on how to charge camera battery pack, see U424AA section of U424AA & L4248 Series : Charging Instructions

What is included in the box?

Setup 2K Wire-Free Camera

1. Turn the adjustment ring counterclockwise to loosen and angle the camera.

2. Screw in the antenna.

3. Insert the battery pack into the bottom of the camera.

You will hear a ‘beep’ when the power pack is properly inserted. If you do not hear this alert, remove the power pack by pushing in on the battery release tabs, then re-insert.

Install 2K Wire-Free Camera

1. Set the mounting bracket in the desired mounting position.

2. Mark holes through the mounting bracket.

3. Using the included drill bit, drill holes where marked.

4. Using the included screwdriver, secure the bracket with the provided mounting screws.
   Optional: If you are mounting the camera into drywall, use the provided drywall anchors.

5. Align the camera’s mounting plate slots to the tabs in the mounting bracket. Push in and slide down to secure in place.

6. Insert the security screw through the fasteners on the top of the camera and mounting bracket, then tighten with the screwdriver.

7. Tighten the pre-installed locking screw using the screwdriver.
   Note: To remove the power pack in the future, loosen the locking screw.

8. Adjust the camera to the desired position. Tighten the adjustment ring clockwise.

Setup camera with Lorex Cirrus app?

For full instructions on how to connect camera with Lorex Cirrus app, see Connecting with Lorex Cirrus app.